| |
|
|
 |
 |
 |
| Lift the seat and with an awl or tip of
a screwdriver push down the center of the two clips at
... |
|
| Lift and remove the battery cover. It's
best to lift from the rear where the clips are ... |
|
| On the "Thank You"
letter that was shipped with your tank bag there is a
template at the ... |
|
 |
 |
 |
| After the template is cut out, place it
on the front of the battery cover. Mark the ... |
|
| Drill two 9/64" holes where the marks
appear on the battery cover. If you don't have a ... |
|
| Place the machine screw through the center
of the button snap and then place this through ... |
|
 |
 |
 |
| On the back side of the battery cover place
the washer and nylon lock nut over the machine ... |
|
| Your clips will look like the "before"
clip when you remove the battery cover initially ... |
|
| Replace the battery cover by putting the
front end in first. |
|
 |
 |
 |
| Replace the clips and push down on the center
pin until they "lock" into place. |
|
| Remove each strap from the tank bag and
adjust each one so that it measures 5 ¼".
This ... |
|
| Snap each adjusted strap to the button snaps
and lay each strap so that they go toward the ... |
|
 |
 |
 |
| Close the seat and make sure that the quick
release clips are visible from under the seat. |
|
| Remove the handlebar cover by first removing
the two rear screws with a Phillips ... |
|
| Continue by removing the front two screws
and the two 5 mm Allen bolts. You will need to ... |
|
 |
 |
 |
| Remove the handlebar cover and be sure you
are careful not to damage the locking tabs at ... |
|
| Place the tank bag in position by clipping
it in via both rear quick-release clips. Make sure that
... |
|
| Center the handlebars. Hold the mounting
tab at the front end of the tank bag up to the dash ... |
|
 |
 |
 |
| Pull the mounting tab out of the way and
with an awl, mark a pilot hole where the button ... |
|
| With the same size drill bit that you used
to drill the previous holes on the battery cover... |
|
| Insert the machine screw through the hole
of the button snap and place this through... |
|
 |
 |
 |
| After the nylon lock nut is started, hold
it with an 8 mm or 5/16" open/closed end ... |
|
| Attach the mounting tab at the front of
the tank bag to the button snap that was just ... |
|
| Now stand back and take a look at your work.
Good job! You now have a great extra storage ... |
|